ÆTSETANK

Facts about the tank:

Contents: approx. 15 litres of ferric chloride
Max plate size:  2 pieces “45x60 cm-plates” (or more smaller plates) can be etched simultaneously.

Outside dimensions: 64 cm x 53 cm (height) x 14,5 cm (top)
A separate stand provides exceptional stability: 52cm long, 26cm wide and 25cm high which.
Weight about: 9 kilos with stand and accessories

Accessories:

Aquarium aerator pump mrk. Elite 802
2 x 2½ meter air tube
2 x 100 gram air stones
2 valves to airflow control

Its design features include:

An extended drip ledge, which makes removing plates from the tank to the sink safer and mess-free and it gives the possibility to build-in the tank in a table next to the sink.
A snap-on, form fitting lid to prevent evaporation
Aerator pump (see drawing) with airflow control to activate the ferric chloride before etching and dissolve sediments after etching.

Other:

A full tank that contains about 15 litres will last approximately two years of frequent, daily use. If the ferric chloride is out of use for a period of time, it may lose its edge. You can ‚whet its appetite‘ it by feeding it a piece of copper a few hours before etching. The safest and easiest way to empty the tank is by means of an aquarium pump.

Shipping:

The tank and accessories with be shipped by parcel pos in a carboard box 66x60x23cm – weight 10 kilos.

www.GrafiskEksperimentarium.dk